|
OmniTurn announces the
introduction of the FastZip rear end loader. OmniTurn lathes and
attachments have been designed for fast, high volume, precision
turning. Here is a loader that has been designed to enhance the
OmniTurn and make it more productive. The loader is simple, yet it
covers a very wide range of needs for a shop with production
turning. The OmniZip can be used as a short bar feed, then changed
over to hand single operations on long thin parts.
Features
- FAST: Part to part load time is
under 5 seconds. Much faster than other rear end loaders that
take up to 15 seconds per part
- Simple installation:
- Intended for use with the
OmniTurn GT-75, OmniTurn GT-Jr., and OmniTurn attachments.
- The OmniZip bolts to the back
of the OmniTurn and plugs into a simple interface.
- Self contained controls and
electronics. The unit comes fully assembled. Bolt it to the
floor
Versatile:
- Load bars up to 24” long.
Perform standard bar feed type operations.
- Load a bar to a stop on the
slide
- Machine a part and cut off
- Push the bar to the stop for
the next part
- When the bar is complete,
load the next bar
- Load individual part from
standard infeed rack for secondary operations
- Push new part into spindle
- Pull pusher back .1”
- Machine part
- Open collet, push part out of
collet
- Drop back, prepare to load
next part
- Load individual parts from
optional high volume add-ons.
- bowl feed adaptor - escaped
from bowl into track
- Loader mounted Bin to hold up
to 1000 parts
Compact footprint
- Adds only 5’ to the overall
length of the machine
- Only 2’ wide
· Easily removed to machine
- Can be removed easily for
storage
- Or moved from machine to
machine
· Simple to maintain and service
- Simplicity is key, all
components are available off the shelf
- Open construction aids in setup
and care
- Off the shelf, American made
electronics and components
|
