|
|
|
 |
|
|
OmniTurn
Sales Headquarters
40 Allen Blvd.,
Farmingdale, NY 11735, United
States
Tel: (631) 694-9400 | Fax: (631) 694-9415 |
|
|
|
 |
|
ACCESSORIES: |
-
Control Parts, Servo Amps,
Monitors, Keyboards
-
Ball Screws, Thrust Bearings,
Linear Ways, Axis Motors, Motor Couplings
-
Spindle, Collet Closers, Spindle
Encoder, Encoder Belts
|
|
|
If you have had your OmniTurn for a number of
years you might want to take a few hours and go over your
investment to make sure it is running at its best. There are
a number of simple items to check and adjust that can effect
the system’s performance. OmniTurn's technical support staff
is always on hand to help with either walking you through
procedures over the phone or arranging a technician to
perform the work for you. Here is a list of items that
should be checked periodically:
• Clean and lubricate linear ways and ball screws
• Balance Servo amps
• Clean and adjust the monitor
• Clean floppy disk drive
• Replace Pneumatic regulator/filter element or assembly
• Replace thrust bearing
• Encoder pulley and belts
• Spindle drive belt and tension
• Inverter output RPM at 0 and max rpm
• Braking resistor condition
• Adjust spindle drive Accell and Decel rates
• Check axis motor cables, no cracks or breaks
• Replace X axis brake bumper |
|
|
| |
