Simultaneous 2 axis moves
- X and Z
- X and C
- Z and C
Simultaneous 3 axis moves
- X, Z, and C
Built-in full text editor, on and off line
Free program verification, on and off line
Free tool path graphics, on and off line
Tool nose radius comp
Auto corner chamfer for perpendicular
and non perp. linear moves
Auto corner radius for perpendicular
and non perp. linear moves
Decimal point programming
Threading 180 tpi to 1/2 tpi, Multi Start and
tapered, I/D and OD, Inch/Metric
Combined use of abs. and Inc. programming
Radius or diameter programming
Inch or metric programming
Constant surface feet spindle speeds
Tool offset storage: 32 per program
Secondary offsets: 32 per program
Parts counters, up and down
Least increment: .00005" / .001mm
Work shift offsets
Rapid travel: 300"/min, effective as 600"/min
Accel and Decel: .02 seconds min to max
Feed rates: .0005"/rev to 300"/min
Thrust: 300# continuous, 700# peak
Servo update time: .001 second
Servo loop gain: 4"/minute/millivolt
Arc sphericity: +/- .0005"
101 key keyboard
9" CRT display
Operator station
10 Meg Hard Disk
Single floppy disk drive
Program storage: Floppy or Hard disk
Floppy: 9000 per floppy
Hard disk: 20,000
RS-232 interface
Network ready
4 meg RAM
NO BATTERY back ups, save on disk
No air pulled for cooling
Jog mode with joy stick
- Continuous modes: 1", 10", 100"/min
- Incremental: .00005", .001", .01", .1", 1"
Automatic mode
- Program run
- Single block operation
- Continuous mode
- Optional block delete
Block search to
Tool offset correction
Program editor
Spindle over ride: 10 to 120%
Editor lock
Disk operations
- Delete programs
- Rename programs
- Duplicate system disk
- Duplicate user disk
- Automatic backing up to floppy or network
- Update system software
Threading: Inch/Metric, OD/ID, Tapered, Multi-start, Angle infeed, single pass
MDI mode
|
 |
|||||||||||||||||
