OmniTurn

X axis travel	12"
Z axis travel	9"
Center height	3/8", 1/2" or 5/8"
Tooling plate	14" x 6"
Tooling type	Gang type
Axis repeatability	.00005"
Axis resolution	.00005"
Axis accuracy	.0001"
Control	OmniTurn
Rapid travel	300 ipm
Feed rate	Slowest .00005"/rev Fastest 300ipm
Threading	Finest 240/inch Coursest .5"/rev
Axis thrust	300# maintained 500# peak
Axis motors	Servo - Closed loop 4000 counts per rev.
Axis time for 0 to 300ipm	.02 second
Construction
Linear ways	20mm THK
Ball screws	5/8" diameter - 5 pitch
Base billot	15" x 50" x 6" MJ7 composite
Headstock	Cast Iron
Surface finish	Heavy duty powder coat
Coolant pump	1/8hp @3800rpm
Spindle - Standard
Cartridge type	Class 7 angular contact
Spindle taper - ID	5C
Spindle taper - OD	Plain or Cam-lock
Spindle RPM - standard drive	100 - 4000 rpm 200 - 5,000 or 6,000 opt
Spindle HP - standard drive	5HP
Speeds programmed as	RPM and CSF
Collet closer	Pneumatic
Collet closer pull force	1,800# at 80psi
C axis spindle
Spindle RPM	0 - 4000 standard 0 - 5000 optional
Spindle HP - C axis	4.5hp
C axis resolution	.1 degree
Speeds programmed as	RPM, CSF, C, C/X, C/Z, C/X/Z
Requirements
Air	3 CFM
Electrical	110V - 10amp 220V - 20amp
Floor plan - GT-Jr	32" x 50"